Fujitsu MBA3300FD Product Manual page 72

Installation
(3) Control mode parameters (page code = A)
The following parameters are used to control the tagged queuing and error logging.
a. Control mode parameters
• QUEUE ALGORITHM MODIFIER
• QErr:
(4) Fibre channel control parameters (page code = 19)
Refer to Subsection 4.1.4 "MODE SELECT (15)" of the FIBRE CHANNEL INTERFACE
MANUAL for details.
• DTOLI (Disable Target Original Loop Initialization)
• DTIPE (Disable Target Initiated Port Enable)
• ALWLI (Allow Login Without Loop Initialization)
• RHA (Require Hard Address)
• DLM (Disable Loop Master)
• DDIS (Disable DIScovery)
• PLPB (Prevent Loop Port Bypass)
• DTFD (Disable Target Fabric Discovery)
Note:
It is prohibited that "1" is specified in DTIPE and PLPB simultaneously. If DTIPE=PLPB=1 is
specified, it responds with CHECK CONDITION (ILLEGAL REQUEST, VALID FIELD IN
THE PARAMETER LIST.)
66
Parameter
Resume or abort remaining suspended
commands after sense pending state
Parameter
Default value
0 (Execution sequence of
read/write commands is
optimized.)
0 (command is resumed)
Default value
0 (An Initializing LIP is issued
when the HDD enters the Loop.)
0 (The HDD does not have the
Loop Port Enable primitive, so it
enters the loop port.)
0 (The HDD carries out
confirmation of the address in the
Loop Initialization process.)
0 (In the Loop Initialization
process, try fixing a soft address.)
0 (The HDD itself is permitted to
become the Loop Master.)
0 (Before the initiator restarts task
processing, it must wait for
Address Discovery or
Port Discovery.)
0 (Receiving Loop Port bypass
(LBP)/Loop Port Enable(LPE)
Primitive, it controls Port Bypass
circuit according to the received
Primitive.)
0 (Fabric connection is enabled.)
C141-E264