AMX NXD-CV7 Instruction Manual page 69

2. Power-up the panel (this allows it to detect the card).
3. Press the Protected Setup button (located on the lower-left of the panel page) to open the
Protected Setup page and display an on-screen keypad.
4. Enter 1988 into the Keypad's password field and press Done when finished.
5. Press the Secondary Connection button (located on the lower-left) to open the Secondary
Connection page.
6. Locate the Wireless Settings section of the Secondary Connection page (FIG. 58).
FIG. 58 Secondary Connection page (Wireless Settings section)
You must first take the SSID name, Current Key string value, and panel MAC Address
information and then later enter it into the appropriate WAP dialog fields in order to
"sync-up" the secure connection. These values must be identically reproduced on the
target WAP.
7. Touch the Network Name (SSID) field and from the Service Set Identifier keyboard, enter the
SSID name you will be using on your target Wireless Access Point (case sensitive).
8. Leave the Authentication field reading Open System (default).
7" Modero Widescreen Touch Panels
The card should be given the SSID used by the target WAP. If this field is left blank, the
unit will attempt to connect to the first available WAP. By default, all WAP200Gs use
AMX as their assigned SSID value.
One of the most common problems associated with connection to a WAP arise because
the SSID was not entered properly. You must maintain the same case when entering the
SSID information. ABC is not the same as Abc.
The alpha-numeric string is by default AMX but can later be changed to any 32-character
entry. This string must be duplicated within the Network Name (SSID) field on the WAP.
As an example, if you use TECHPUBS as your SSID, you must match this word and
the case within both the Network Name (SSID) field on the touch panel's Network Name
SSID field and on the WAP's Basic Wireless Configuration page.
Open System Authentication allows any device to join the network if the panel's SSID
matches the WAP's SSID. An Open System is recommended for communication
between Modero panels and an NXA-WAP200G.
SSID field
Wireless card communication
settings (for use with a target WAP)
Changes on this page take
effect after using the BACK
button to return to the
previous page
Configuring Communication
61