AMX NXD-CV7 Instruction Manual page 45

A - Faceplate
/Trim Ring
FIG. 37 Wall Mount panel (NXD) installation configuration for drywall surfaces
Don't disconnect the connectors from the touch panel. The unit must be installed with
the attached connectors before being inserted into the drywall.
6. Test the incoming wiring by attaching the panel connections to their terminal locations and
applying power. Verify the panel is receiving power and functioning properly to prevent
repetition of the installation.
7. Disconnect the terminal end of the power cable from the connected PSN power supply.
8. Install the three sets of drywall screws and expansion clips into the three oval notch locations
along both sides of the main unit (B in FIG. 37).
9. Carefully insert the main unit (with expansion clips) into the cutout until the Mounting Tabs on
the NXD unit lie flush against the wall.
The drywall clip set must be re-ordered from AMX if the drywall clip is bent
accidentally during an installation or removed during a re-installation.
10. Tighten all three drywall clip sets (screws and clips) until the entire Mounting Tab is securely
fastened and flush against the wall.
11. Place the Faceplate (A in FIG. 37) back onto the main NXD unit (B in FIG. 37). Make sure to
align the Microphone, Light, and PIR Motion sensor locations to their respective openings on
the front faceplate/bezel.
7" Modero Widescreen Touch Panels
Install the 3 included
drywall clip sets
into these locations
Drywall Clip (3)
Mounting Tab
B - Main NXD unit consists of
the touch panel and back box
Installation
3 notches are
required to
accommodate the
three expansion
clips (included)
37