AMX NXD-CV7 Instruction Manual page 115

Secondary Connection Page Elements (Cont.)
Access Point MAC
Address:
Wireless Settings:
Network Name (SSID)
Authentication
Encryption
7" Modero Widescreen Touch Panels
This value is factory set by the manufacturer of the Wireless Access Point
(WAP).
When communicating with a WAP200G enter the MAC Address (BSSID) of the
target WAP as the Access Point MAC Address. Refer to the WAP200G
Instruction Manual for more detailed information on the interaction between
these two product lines.
Sets the communication values for the NXA-WC80211B/CF wireless interface
card installed within the Modero panel.
Provides the Service Set Identifier (SSID), required by the panel, before it is
permitted to join the wireless network. The SSID is the unique name used on
the WAP and assigned to all panels in a wireless network that are communicat-
ing to the same target WAP.
• It is case sensitive and must not exceed 32 characters, which may be any
keyboard character. Make sure this setting is the same for all points in your
wireless network.
• This unique string identifies the network and is the same string for all users on
the same network.
CV7 panels only allow one mode: Open System.
• An Open system network allows connections from any client without
authenticating whether that client has permission to associate with the
network.
Cycles through the available encryption options: Clear Text, WEP64, and
WEP128. Wired Equivalent Privacy is an 802.11 security protocol for wireless
networks. The WEP encryption method is designed to provide the "equivalent"
security available in wireline networks.
• Clear Text causes network packets to be sent out as unencrypted text.
• WEP64 enables WEP encryption at 64-bits. In this case all packets will be
transmitted with their contents encrypted using the Default WEP Key.
• WEP128 enables WEP encryption at 128-bits. All packets are transmitted with
their contents encrypted using the Default WEP Key.
• If the key is not the correct size, the system will resize it to match the
number of bits required for the WEP encryption mode selected.
Firmware Pages and Descriptions
107