Troubleshooting - Fujitsu AMILO LXL 3220W Operating Manual

Troubleshooting

Should an error occur, first check the following points. If the distortion is still not eliminated,
the monitor should, if possible, be checked on another computer.
If you are unable to solve the problem, please inform our help desk.
Having this problem?
No screen display
Power indicator does not light up
No screen display
Power indicator is lit
Message: No Signal
Message: Frequency out of range: ## kHz
/ ## Hz Please change the display mode
to 1680 x 1050 with 60 Hz
Picture position not correct
Picture is shaking
Picture is wrongly adjusted
Picture disturbances (vertical lines)
A26361-K1300-Z120-1-7619, edition 2
Check the following points:
► Check whether the power cable on the
monitor is connected correctly.
► Check whether the computer is switched on.
► Check whether the computer is switched on.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Press any key on the computer keyboard.
The computer may be in power saving
mode.
► Alter the brightness and/or contrast until you
get a picture.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Check whether the computer is switched on.
The input signal (horizontal frequency and
refresh rate) at the displayed input does not
correspond to the technical data for the monitor.
► Adjust the video frequency range using the
computer software (see documentation for
the computer or display adapter).
► Set a different screen resolution using the
computer software (see documentation for
the computer or display adapter).
The monitor recognises an undefined mode (see
chapter "Technical data", Page
► Press the EXIT / AUTO
auto-adjustment of the screen.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Press the EXIT / AUTO
auto-adjustment of the screen.
► Press the SELECT / MENU
activate the Factory Recall function.
The Auto Processing message appears.
► Press the EXIT / AUTO
auto-adjustment of the screen.

Troubleshooting

26).
button to perform
button to perform
button to
button to perform
23