Flex Coupler - Land Pride 312-517M Operator's Manual

Section 4: Maintenance & Lubrication
Do Not Overfill
IMPORTANT: Your cutter is shipped with a vented
dipstick packaged in the Operator's Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
Do Not Overfill
30263
IMPORTANT: Your cutter is shipped with a vented
dipstick packaged in the Operator's Manual bag and
should have been installed in the gearbox by your
Land Pride dealer. Please see your Land Pride dealer
if vented dipstick was not included.
36 RCR3596, RCRM3596, RCR3510 & RCRM3510 Rotary Cutters 312-517M
Table of Contents
30215
Gearbox
NOTE: Do not overfill! Cutter should be level when
checking oil. Oil expands when hot, therefore, always
check oil level when cold.
Method 1: Unscrew top vented dipstick (#1). Wipe oil from
dipstick and screw dipstick in without tightening. Unscrew
dipstick and check oil on dipstick. If below bottom level
mark, add recommended gear lube through dipstick hole
until oil reaches top mark on dipstick. Reinstall vented
dipstick and tighten.
Method 2: Remove side oil plug (#2). If oil is below bottom
of plug hole, add recommended gear lube through top
dipstick hole until oil flows out of side plug hole. Reinstall
and tighten side oil plug (#2) and vented dipstick (#1).
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out the side plug hole in the gearbox.
T-Gearbox
Check oil level in gearbox by removing upper rear plug in
gearbox case. If oil is below rear plug hole, add
recommended gear lube through top plug hole until oil
flows out of rear plug hole. Reinstall oil plugs and tighten.
NOTE: Do not overfill! Cutter should be level when
checking oil.
Type of Lubrication: 80-90W EP Oil
Quantity = Fill until oil flows from upper rear port of gearbox
housing.

Flex Coupler

Type of Lubrication: Grease
Quantity = As required
16276
8
Hrs.
8
Hrs
8
Hrs
8/15/12