Table of Contents
Advertisement
Section 4: Maintenance & Lubrication
Tire Maintenance
!
WARNING
Tire changing can be dangerous and should be preformed by
trained personnel using correct tools and equipment. When
removing and installing wheels, use wheel handling
equipment adequate for the weight involved.
!
WARNING
Always release all air pressure in air filled airplane tires
before removing hardware bolting their split rims together.
Not doing so can cause the split rims to blow apart instantly
and could resulting in serious injury or death.
!
WARNING
When inflating tires, use a clip-on chuck and extension hose
long enough to allow you to stand to one side and NOT in front
of or over the tire assembly. Use a safety cage if available. Do
not overinflate tires.
!
WARNING
Do not weld on or heat a rim. If a tire is mounted to the rim,
air pressure inside the tire can increase enough to cause an
explosion. High heat can also weaken and/or warp the rim,
damage the tire, and destroy foam filling inside a tire.
1. Check tires for low air pressure, missing nuts,
missing lug bolts, wear, separated rubber, and bent,
broken, or cracked wheel rims.
2. Inflate air filled tires to the proper pressure. Refer to
"Tire Inflation Chart" on page 42.
Refer to Figure 4-6:
3. Replace wheel rims and tires as needed with
genuine Land Pride parts. Do not loosen split rim
hardware (#1) until all air pressure in the tire has
been removed.
Air Filled Airplane Tires with split Rims
Figure 4-6
8/15/12
Table of Contents
Skid Shoe Maintenance
Refer to Figure 4-7:
!
Excessive wear on skid shoes can damage side panels, cause
inadequate operation of cutter, and create a safety hazard.
Always replace skid shoes at the first sign of wearing thin.
There are two skid shoes mounted on the cutter sides.
Check both skid shoes for wear and replace if needed.
Order only genuine Land Pride parts from your local
Land Pride Dealer.
Land Pride Skid Shoe Replacement Parts
Part No.
312-602D
802-466C
803-198C
1. Remove 3/8" hex whiz nuts (#3), 3/8" plow bolts (#2)
2. Plow bolts should be checked for wear and replaced
3. Attach new skid shoe (#1) to cutter with existing
4. Repeat on opposite side.
1
33925
RCR3596, RCRM3596, RCR3510 & RCRM3510 Rotary Cutters 312-517M
WARNING
Skid Shoe Replacement
Figure 4-7
Part Description
SKID SHOE
PLOW 3/8" - 16 x 1 1/4" GR5
NUT HEX WHIZ 3/8-16 PLT
and skid shoe (#1) as shown.
if necessary.
3/8" plow bolts (#2) and secure with 3/8" hex whiz
nuts. Torque to 31 ft. lbs.
22454
33
Advertisement
Table of Contents
