Table of Contents
Advertisement
Section 1: Assembly and Set-Up
Pull-Type Hook-Up
Refer to Figure 1-8:
!
DANGER
A Crushing Hazard exists when hooking-up equipment to a
tractor. Do not allow anyone to stand between tractor and
implement while backing-up to implement. Do not operate
hydraulic 3-Point lift controls while someone is directly
behind tractor or near implement.
!
WARNING
Always disengage PTO, engage parking brake, shut off
tractor, remove ignition key, and wait for all moving parts to
come to a complete stop before dismounting from tractor.
Distances between center of drawbar hitch pin hole to
end of tractor PTO shaft and from top of drawbar hitch to
center of PTO shaft must be maintained for Pull-type
hitches. See "Pull-Type Hitch" on page 9 for distances.
IMPORTANT: Jack attachment pin must be fully
inserted and secured before working on or around a
cutter not hooked to the tractor drawbar.
1. Make certain jack stand (#1) is properly attached to
cutter hitch and secured with attachment pin (#2).
2. Back tractor within close proximity of cutter
clevis (#6).
3. Raise or lower jack (#1) to align clevis (#6) with
tractor drawbar. Drawbar should fit between lower
and upper plates of clevis.
4. Back tractor up to cutter hitch until holes in the
drawbar and clevis (#6) are aligned.
14
RCR3596, RCRM3596, RCR3510 & RCRM3510 Rotary Cutters 312-517M
Table of Contents
5. Insert 1" flat washers (#5) above and below tractor
drawbar.
6. Insert 1" -8 x 4 1/2" GR5 hex bolt (3) through top of
clevis (#6), 1" washer (#5), drawbar, remaining 1"
washers (#5) and out through bottom of clevis (#6).
Secure bolt with locknut (#4). Tighten nut snugly to
remove all play and then back nut one-quarter turn.
NOTE: May need to adjust the leveling rod nut
couplers to obtain correct drawbar height.
7. Attach driveline yoke end (#8) to tractor PTO shaft.
Secure with locking device. Pull on both end of the
driveline to make sure it is secured to the tractor and
gearbox shafts.
8. Hook driveline safety chain to the tractor. Re-latch
safety chain to the driveline shield.
9. Attach hydraulic hose (#9) to tractor hydraulic outlet.
10. Fully retract the jack stand (#1), remove locking pin
(#2) and store parking jack on the cutter deck with
locking pin as shown.
Safety Chain
Refer to Figure 1-8:
When towing implements on the highway, use a safety
chain (#7) with tensile strength equal to or greater than
the gross weight of the implement to be towed by the
tractor. This will control the implement in the event the
hitch pin is lost.
After attaching safety chain (#7) to the tractor, make a
trial run by driving the tractor to the right and to the left for
a short distance to check the safety chain adjustment. If
necessary, re-adjust to eliminate a tight or loose chain.
Make sure chain hook is securely locked in place.
RCR3510 jack storage location shown
with arrow. Jack storage location is on the
deck top for RCR3596 & RCRM3596
Pull-Type Tractor Hook-Up
Figure 1-8
16260
8/15/12
Advertisement
Table of Contents
