Table of Contents
Advertisement
2.1 RAIL INSTALLATION
The Jupiter expander Rack 835 storage system comes with rack mount slide rails attached to the sides of the unit
and the necessary screws and cage nuts for installing into 4-post square-hole rack systems. To install the slide rail
brackets into your rack, do the following:
1.
The Jupiter expander Rack 835 requires two
rack units of space, take note of which units
on your rack that you will install Jupiter into.
2.
Install the included cage nuts into your rack
using Figure 2.1a as a guide for cage nut
placement within the 2U's that have been
designated for Jupiter.
3.
on the Jupiter unit, remove the securing
screw from the rail on the left and right sides
as seen in Figure 2.1b.
4.
once the securing screws have been
removed, remove the rail arm from the Jupiter
unit by sliding it toward the rear of the unit as
seen in Figure 2.1c. When the rail arm stops,
push the release tab while continuing to slide
the rail arm off. after removing the rails, set
them aside taking note of the side from which
they were removed.
5.
Remove the rail arm extensions from the
accessories box and match them to the
rails. Use Figure 2.1d as a guide for proper
matching of rails and the extension pieces.
OWC Jupiter Mini-SAS
sYsTeM seTUP
Left Rail
7
Front Placement
Rear Placement
Figure 2.1a
Figure 2.1b
Push to release
Figure 2.1c
Left Rail
Right Rail
Extension
Extension
Shorter gap
Figure 2.1d
Securing screw
Slide
Right Rail
Shorter gap
SySteM Setup
Advertisement
Table of Contents
