Quadra-Fire SANTAFE-MBK Owner's Manual Installation And Operation page 35

Santa Fe Pellet Stove
C. Blower Replacement
1. Convection Blower Replacement
a. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
b. The Convection Blower is located on the fl oor at the
rear of the appliance.
c. Remove the right upper and lower side curtains by loos-
ening 7/16" nut in th back and lift off of the appliance.
When re-installing fl ex curtain to re-attach.
35.1.
d. Cut the tie wire holding the wires togehter and then dis-
connect the white and purple wires.
e. Remove wingnut and hold-down bracket and then
remove blower.
f. Re-install in reverse order.
g. Attach new tie wire to hold wires together.
Back of Side Curtain
Ribs on Curtain Slide into
Slots at Top and Bottom
Figure 35.1
Figure 35.2
September 3, 2009
Figure
Slot
2. Combustion Blower Replacement
a. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
b. Remove both upper and lower side curtains. Figure 35.1.
Remove the upper and lower rear curtains. Figure 35.3.
c. Disconnect the white and blue wires from the exhaust
blower.
d. There is a removable plate on the exhaust blower. Using
a 1/4" socket or short standard screwdriver loosen the 6
screws in the keyhole shaped holes and rotate the plate.
Figure 35.4
e. Remove the exhaust blower and gasket.
f. Re-install in reverse order.
Remove the circled screws to
remove the upper and lower rear
screens.
Figure 35.3
Figure 35.4
7050-128B
Side curtains slip under the 6 nuts
identified by the square marking.
R
Page 35