Coolant Level Inspection; Tire Inspection - KYMCO People S 250 Owner's Manual

OPERATION
PRI - Engine coolant level inspection
The engine coolant in the radiator will flow into the coolant
reservoir as the engine gets hot. This expelled coolant will flow
back into the radiator as the engine cools. Because of this
normal transference, periodic inspection of the coolant reser-
voir is required. If too little coolant is in the reservoir, the cool-
ant level in the radiator may not be replenished as the engine
cools. Too much coolant in the reservoir may indicate a prob-
lem with the cooling system.
1. Make sure the scooter is parked upright, on its main stand.
1 1 1 1 1
2. Visually confirm that the coolant level in the reservoir inspec-
tion window 1 is above the "L" mark but not higher than the
"F" mark. Open the access panel (above the inspection win-
dow) to add or remove coolant as required.
26
PRI - Tire inspection
The condition of your scooter's tires is vital for operational ef-
ficiency and for your safety. Check the tires' inflation pressure
2, the tread depth, and for damage before each ride.
F
L
Only use a 50:50 mixture of antifreeze and distilled
water in the coolant reservoir. Do not open the ra-
diator cap, especially if the engine is warm. If your
radiator or other cooling system components require
service, see your KYMCO dealer.
Front tire (rider only):
Rear tire (rider only):
Front tire (rider & passenger): 25.0 PSI (1.75 kg/cm
Rear tire (rider & passenger): 32.0 PSI ( 2.25 kg/cm
2 2 2 2 2
25.0 PSI (1.75 kg/cm )
2
29.0 PSI (2.0 kg/cm )
2
)
2
)
2