Float Chamber Assembly; Float Level Inspection - KYMCO SUPER8 50 2T Service Manual

11
. CARBURETOR

FLOAT CHAMBER ASSEMBLY

Install the main jet and needle jet holder.
Install the air screw and throttle stop screw
according to the rotations recorded.
＊
If the air screw must be replaced, be
sure to perform
adjustment again.
Install the float valve, float and float pin.
Tighten the float screw securely.

FLOAT LEVEL INSPECTION

Slightly tilt the carburetor and measure the
float level with
connecting the float arm.
Float Level: 8.6mm
Replace the float if the level is out of the
specified level range.
Install the O-ring.
Check the operation of the float and install
the float chamber.
Tighten the screws.
the air screw
the float valve just
Needle Jet holder
Throttle Stop Screw
Air Screw
Float Pin
SUPER8 50 2T
Main Jet
Slow Jet
11-10