Suggested Machine Installations - Asko D5644 Operating Instructions Manual

Installation

Suggested machine installations

The dishwasher can be installed built-in, completely
freestanding or partially built-in.
A. Built-in
The dishwasher is intended for installation under a
worktop. The recess dimensions are illustrated. Holes
for wires/cables need not be larger than 38 mm in
diameter. Make sure the edges of such holes are even
to prevent damage to the drainage and inlet hoses
and the power cable.
*Remove washers and glide foot for an
installed height of 820-824 mm.
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip
brackets. This comprises two brackets, which are
screwed into place as illustrated.
Next, slide the dishwasher into place so that the
brackets grip the rear feet. Now the dishwasher will
not tip over if a load is placed on the door when open.
If the dishwasher is installed completely freestanding,
side panels and a worktop should be fitted. These
accessories can be purchased where you bought the
dishwasher.
[mm]
600
> 550
49
820*-878
136
WARNING!
A completely freestanding dishwasher must be fitted
with anti-tip brackets.
C. Partially built-in
If the dishwasher is installed so that either side is
visible, you can fit a side panel. These accessories
can be purchased where you bought the dishwasher.
33