Moving The Machine Into Place - Asko D5954OUTDOORPH Installation Instructions Manual

MOVING THE MACHINE INTO PLACE

1. Position the machine in front of the cabinet opening.
2. Push the plastic feet into place on all steel feet
(included in document bag). (Only certain models.)
3. Start by measuring the height from the floor to the
bottom edge of the counter top. Measure the height
from the floor to the top edge of the dishwasher.
4. Loosen the lock nuts on the dishwasher's steel feet
using a 5/8˝ (16 mm) open-ended wrench. Screw the
lock nuts down as close to the floor as possible.
5. Make the height adjustment while the dishwasher is
in front of the opening. Adjust all feet by turning them
clockwise to raise or counterclockwise to lower the
dishwasher.
6. Check that there is a 1/8 inch (3 mm) space between
the top of the dishwasher door and the underside of
the countertop.
7. Tighten the lock nuts on the rear feet.
Lock nut
Foot
8. Pull out the drain hose to ensure there are no sharp
bends.
9. Start to feed water and drain lines and electric cord
(if necessary) into the access hole(s) in the cabinet.
10. Gently slide the unit into the dishwasher opening. As
you do this, feed the drain line and inlet hose into the
access hole(s) in the side of the cabinet.
11. If installing in a metal cabinet, the hole(s) for the drain
hose and connection pipe must be fitted with edge
protectors/rubber grommets.
12. Place the spirit level on the dishwasher door to check
that the machine is level and adjust if necessary. The
door must be fully closed!
13. Make any final adjustments to the front feet. (The
machine may have an inclination of 3/16˝ (5 mm)
maximum without affecting its performance.)
14. When the front feet are properly adjusted, tighten the
lock nuts to the base pan.
15. Once the steel feet are properly adjusted, tighten the
two rubber feet against the floor. The rubber feet now
prevent the machine from tipping over.
Page 8
WARNING!
Make sure you put the protective slides on the legs
to prevent damaging the floor when you slide the unit
into place (see page 6).
As you do this, feed the drain line and inlet hose into the
access hole(s) in the side of the cabinet. Use caution
when sliding the dishwasher into place. The protective
slides could cause damage to certain types of soft
flooring.
WARNING!
Be careful of sharp edges.
Customer Care Center
1-800-898-1879
www.askona.com