Suggested Machine Installations - Asko D5424 Operating Instructions Manual

SUGGESTED MACHINE INSTALLATIONS

The dishwasher can be installed built-in, completely freestanding
or partially built-in.
A. Built-in
The dishwasher is intended for installation under a worktop. The
recess dimensions are illustrated. Holes for wires/cables need not
be larger than 38 mm in diameter. Make sure the edges of such
holes are even to prevent damage to the drainage and inlet hoses
and the power cable.
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip brackets.
This comprises two brackets, which are screwed into place as
illustrated.
The dishwasher is then pushed in so that the brackets engage the
rear feet. Now the dishwasher will not topple if pressure is put
on the open door. If the dishwasher is installed completely on its
own, side panels and a worktop must both be fitted. Accessories
can be purchased where you bought the dishwasher.
WARNING!
A completely freestanding dishwasher must be fitted with anti-tip
brackets.
C. Partially built-in
If the dishwasher is located so that one of its sides is visible, a side
panel must be fitted. Accessories can be purchased where you
bought the dishwasher.
ADJUST THE HEIGHT AND SLIDE THE
DISHWASHER INTO PLACE
1 Start by measuring the height from the floor to the bottom
edge of the worktop.
2 Measure the height from the floor to the top edge of the
dishwasher.
3 Adjust all feet by turning them clockwise to raise or
anticlockwise to lower the dishwasher.
4 Check that there is an air gap of at least 3 mm between the
underside of the worktop and the top edge of the dishwasher.
5 Tighten the lock nuts (lock nut) on the rear feet.
6 Slide the dishwasher into place.
• Pull through the drainage and supply hoses when the
machine is slid into place.
• Check that the hoses have no kinks or sharp bends, and
check that there is nothing that can damage the hoses.
7 Make any final adjustments to the front feet (the dishwasher
may lean no more than 5 mm) and tighten the lock nuts.
If you want to install your dishwasher freestanding, skip steps 1, 2
and 4 above.
19