Asko D5644 Operating Instructions Manual page 28

Troubleshooting
Problem
The dishwasher does not start.
1 minute appears in the display.
Water remains in the dishwasher.
Bad odour in dishwasher.
The dishes are not dry enough.
28
Possible causes
You have forgotten to turn on the main
power switch.
The door is not properly closed.
A fuse/circuit breaker has been
tripped.
The plug is not plugged into the wall
socket.
The water tap is turned off.
Overflow/leaks
A whirring sound (the drainage pump)
is heard from the dishwasher and does
not stop when the main power switch
is turned off.
Check that the Delayed start option
has not been selected.
The program is taking longer than esti-
mated.
Blocked drainage hose.
Kink in drainage hose.
The filters are blocked.
The filter is not locked in completely.
Debris in the drainage pump.
Dirt around the seals and in corners.
Low temperature programs have been
selected for a prolonged period.
Drying power too low.
The dishwasher is not fully loaded.
Rinse aid needs topping up or dosage
is set too low.
Action
Press and hold the main power switch
until the display lights up.
Check.
Check.
Check.
Check.
Check.
Turn off the water tap. Pull out the plug
and call the service division.
Press and hold Start/Stop for three
seconds if you want to cancel the De-
layed start option.
None, next time the program is run the
corrected time will be displayed.
Loosen the drainage hose where it
connects to the sink unit's water trap.
Check that no debris has fastened. Is
the cone-shaped part of the pipe cut
to an inner diameter of at least 14 mm?
Check that the hose is free from kinks
and sharp bends.
Clean the coarse and fine filters.
Ensure filter is completely locked with
handle pointing towards the door.
Clean the drainage pump. See the
section Care and cleaning.
Clean with washing-up brush and low
foaming cleaner.
Run a program with a higher tempera-
ture about once a month.
Activate the Drying option.
Fully load the dishwasher.
Top up with rinse aid or increase the
rinse aid dosage. See the sections
Rinse aid and Settings.
Open the door a little once the program
has finished.