Develop ineo 4000P User Manual page 109

Use
Timeouts
Print Timeout
Disabled
1–255 sec
Timeouts
Wait Timeout
Disabled
15–65535 sec
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Error Recovery
Max Auto Reboots
1–20
Print Recovery
Auto Continue
Disabled
5–255 sec
User's Guide
To
Set the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job.
Notes:
• "90 sec" is the factory default setting.
• When the timer expires, any partially printed page still in
the printer is printed.
• Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print
jobs.
Set the amount of time in seconds the printer waits for
additional data before canceling a print job.
Notes:
• "40 sec" is the factory default setting.
• This setting has no effect on PCL emulation print jobs.
Set the Auto Reboot.
Note: Reboot always is the factory default setting.
Set the Max Auto Reboot.
Notes:
• If the device performs a number of automatic reboots
equal to this setting
time, then the device displays the applicable error instead
of rebooting again.
• 5 is the factory default setting.
Let the printer automatically continue printing from certain
offline situations when these are not resolved within the
specified time period.
Note: Disabled is the factory default setting.
- 109 -
'
s value within a certain amount of