1-Safety Information - Develop ineo 4000P User Manual

1—Safety information
Connect the power cord to a properly grounded electrical outlet that is near the product and easily
accessible.
Do not place or use this product near water or wet locations.
CAUTION—POTENTIAL INJURY: This product uses a laser. Use of controls or adjustments or
performance of procedures other than those specified herein may result in hazardous radiation exposure.
This product uses a printing process that heats the print media, and the heat may cause the media to
release emissions. You must understand the section in your operating instructions that discusses the
guidelines for selecting print media to avoid the possibility of harmful emissions.
CAUTION—POTENTIAL INJURY: The lithium battery in this product is not intended to be
replaced. There is a danger of explosion if a lithium battery is incorrectly replaced. Do not recharge,
disassemble, or incinerate a lithium battery. Discard used lithium batteries according to the
manufacturer's instructions and local regulations.
CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid
personal injury or printer damage:
• Turn the printer off using the power switch, and then unplug the power cord from the electrical outlet.
• Disconnect all cords and cables from the printer before moving it.
• If an optional tray is installed, then remove it from the printer. To remove the optional tray, slide the
latch on the right side of the tray toward the front of the tray until it clicks into place.
• Use the handholds located on both sides of the printer to lift it.
• Make sure your fingers are not under the printer when you set it down.
• Before setting up the printer, make sure there is adequate clearance around it.
Use only the power cord provided with this product or the manufacturer's authorized replacement.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from
a hot component, allow the surface to cool before touching.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional
hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug
the power cord from the electrical outlet before continuing. If you have any other devices attached to the
printer, then turn them off as well, and unplug any cables going into the printer.
CAUTION—SHOCK HAZARD: Make sure that all external connections (such as Ethernet and
telephone system connections) are properly installed in their marked plug-in ports.
This product is designed, tested, and approved to meet strict global safety standards with the use of
specific manufacturer's components. The safety features of some parts may not always be obvious. The
manufacturer is not responsible for the use of other replacement parts.
User's Guide
- 10 -