Table of Contents
Advertisement
Installation and operation
5.2
Switching the Server Blade on and off
V
CAUTION!
If you switch the server blade on and flickering stripes appear on the
connected monitor, switch the server blade off again immediately (see
chapter "Troubleshooting and tips" on page
The On/Off button does not disconnect the device from the mains. To
fully disconnect the device from the mains, you must remove the server
blade from the system unit or switch off the system unit and unplug the
power plug(s).
Using the control panel to switch the Server Blade on and off
The system unit is switched on and the power-on indicator (item 7 in
page
43) is flashing green.
The server blade can be switched on and off as follows:
– To switch the server blade on, press the On/Off button on the server blade
(item 7 in
figure 6 on page
To switch the server blade off, hold down the On/Off button on the
server blade (item 7 in
Defined switch-on/off time
The server blade is switched on and off at the times defined in the ServerView
Operation Manager.
Other On/Off options
– After power failure
Once a server blade has been switched on, it will switch itself on again
automatically after a power failure (irrespective of the setting in the BIOS
Setup).
I
You can also switch the server blade on and off via the system unit
control panel or via the Web interface of the ServerView Management
Blade. Detailed information is provided in the manual "PRIMERGY
BX900 Blade Server Systems ServerView Management Blade S1 User
Interface Description".
BX922 S2
Switching the Server Blade on and off
43).
figure 6 on page
43) for 4 seconds.
Operating Manual
85).
figure 6 on
47
Advertisement
Table of Contents
