Connecting The Power Cord - Pioneer Super Tuner IIID MVH-P8200BT Operation Manual

Connecting the unit

Connecting the power cord

Yellow
Connect to the constant 12 V supply terminal.
Orange/white
Connect to lighting switch terminal.
Red
Connect to terminal controlled by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
Front speaker
White/black
Left
Rear speaker or
Subwoofer (4 )
Green/black
When using a subwoofer of 70 W (2 ), be sure to connect with Violet and Violet/black leads of this unit. Do not
connect anything to Green and Green/black leads.
Not used.
Green/black
This product
Antenna input
Fuse (10 A)
Fuse resistor
Fuse resistor
White Gray
Front speaker
Gray/black
Green Violet
Rear speaker or
Subwoofer (4 )
Violet/black
Green Violet
Subwoofer (4 )
× 2
Violet/black
English Connecting the unit
Microphone input
(MVH-P8200BT only)
IP-BUS input
Wired remote input
(Blue)
Hard-wired remote control adaptor can be connected
(sold separately).
IP-BUS cable
Pioneer IP-BUS
accessories
(sold separately)
Connection method
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking
Right
brake. This lead must be connected to the power
supply side of the parking brake switch.
Blue/white
Connect to system control terminal of the power amp or
auto-antenna relay control terminal (max. 300 mA 12 V DC).
With a 2 speaker system, do not connect anything to the speaker leads
that are not connected to speakers.
Note:
· Change the initial setting of this unit (refer
to the Operation Manual). The subwoofer
output of this unit is monaural.
Microphone
4 m (13 ft. 1 in.)
(MVH-P8200BT only)
1. Clamp the lead.
Power supply side
Ground side
English
2. Clamp firmly with
needle-nosed pliers.
Parking brake
switch