Optional Equipment; Legs; Pedestal - Lopi Spirit Owner's Manual

Stove Legs Installation
There are three different stove legs available for your gas stove: cast brass; cast black; and, black
steel. The instructions for installing the legs are the same for each type of leg.
Raise the stove by inserting some pieces of lumber in the middle of the stove to a height of about
8". Line up the hole in the top of the leg with the threaded bolt hole in each corner of the stove
bottom. Using a 9/16" open end or socket wrench, fasten the leg to the stove with the supplied
attachment bolts and washers, making sure the legs are flush with the corners of the stove.
Unscrew the leveling bolts enough so the stove will rest on the upper tips, not the metal portion
of the legs. Lower the stove down.
Attach each leg to the stove
by inserting a bolt and washer
through the hole or slot in the
leg and into the threaded hole
on the stove. Use a 9/16"
socket wrench to tighten.
To level the stove, lift the stove up and unscrew each leveling bolt the appropriate amount. The
rubber tips of the leveling bolts will tear if they are adjusted while weight is applied to them.

Pedestal

(Part # 99200101)
Unpack the box containing the pedestal and check for any damage. Report any damage to your
dealer.
Place the pedestal in place and lift the stove on top of it. Line up the threaded bolt holes in the
bottom of the stove with the two holes on the tabs on the inside edge of the pedestal (see the
illustration below). Using a 9/16" socket wrench, fasten the pedestal to the stove with the
supplied bolts and washers.
Holes for attachment bolts
Attachment Bolts and
Washers - use a 9/16"
socket wrench to
attach the pedestal to
the stove.
(Brass # 99200500, Cast Black # 99200800, Black Steel # 99200100)
22 1/4"
The faceplate of the stove is
1 3/4" in front of the pedestal
O
PTIONAL
21 7/8"
Lag bolts, cover plates,
screen, insulation, and
staples (used for wood
stoves - discard these items)
E
QUIPMENT
P
AGE
Leveling bolts are
attached to the leg. Do
not have any weight on
the bolts while
adjusting them Ð the
rubber tips may tear.
25