Lopi Spirit Owner's Manual page 29

Thermostat (continued)
Ashlip Control Housing
Route the thermostat through
the notch in the ashlip control
housing partition if it is coming
from the center or left side.
The thermostat wire attaches
to the green wire from the
valve and the green wire from
the on/off switch.
5. Replace the ashlip control housing. Make sure none of the wiring is pinched.
6. Determine the location of the thermostat. Find a location that is centralized in the room and
within reach of 50' of wire. Route the thermostat wire to the location and attach the thermostat
wire to the thermostat. Cut off any excess length of wire and expose approximately 1/2" of wire
for connection to the thermostat. Attach the thermostat wire to the two clips on the thermostat
using a standard screwdriver. Make sure the wire makes a good electrical contact.
Thermostat Front Side
7. Remove the cover of the thermostat by pulling it apart carefully. The thermostat has mounting
holes on each side of its base. Use the included screws to attach the thermostat to the wall. Tuck
any excess wire behind the thermostat and replace the thermostat cover.
8. Test the thermostat's operation prior to leaving the installation. Turn the thermostat to it's highest
position (all the way to the right). Start the pilot, let it run five minutes, then turn the on/off
switch on. The heater should turn on. If it does not, check all of the electrical connections and
re-test. The thermostat should turn the heater on when turned to its highest position, and turn off
when turned to its lowest position. NOTE: if the temperature in the room is not between 50° and
90° this will not work because of the thermostat's range. Wait until a suitable temperature is
achieved in the room before testing the thermostat.
O
PTIONAL
On/Off
switch
Green wire
from valve
Thermostat Back Side
To attach the
thermostat, pull
the cover off and
use the included
screws to hold it
against the wall.
Holes used to attach the
thermostat to the wall.
E (C
QUIPMENT
Piezo
Red wire
igniter
from valve
Green wire
)
ONTINUED
P
AGE
Orange wire from
spark electrode
Blower
Rheostat
Green Jumper wire
(remove and discard)
Strip 1/2" off each
wire and attach the
exposed wire to the
clips using a standard
screwdriver.
Thermostat Wire
29