BLADEZ E-LITE 250 Product Handbook page 9

*It is recommended on initial charge to charge for 6-8 hours even if the light is GREEN.
Unfolding
3. To unfold your E-Lite, hold the unit with one hand, while gently pulling up on the
handlebars with the other.
4. Fully extend the handlebars to their upright position until you feel the mechanism
lock into place.
5. You are now ready to ride your Power Board!
Riding
6. Makes sure that all of the bolts and screws are tightened.
7. Raise the kickstand to its upright position.
8. PRESS THE ON/OFF Button once (Fig 6). The
POWER INDICATOR light will blink RED and
then Turn GREEN (indicating the E-Lite in ON
and ready to ride).
9. Put one foot on the deck of the E-Lite. After
pushing off with the other foot, gently squeeze the
ACCELERATOR LEVER, on the right side of the
handlebars. The Power Board will begin to move
on its own power.
10. Your E-Lite 250 has a variable speed throttle lever. You can control the speed of
your scooter by the amount of pressure you use when depressing the throttle lever.
The more you depress the throttle the faster you will go.
11. To stop, release the accelerator handle and depress the BRAKE LEVER (on the left
side of the handlebars). Depressing the brake will temporarily disengage power to
the motor.
12. When you feel your Power Board moving slow, sluggish or running out of power, it is
time to recharge. (See charging instructions)
* Note that there is still charge in the battery but it is not advisable to fully discharge the
batteries.
Page 9