Quick Release Deck - BLADEZ E-LITE 250 Product Handbook

* Note: It is not advisable to operate your Power Board on low tire pressure. This will negatively affect
speed, handling and performance.

Quick Release Deck

Batteries
Charging
The E-LITE is equipped with a quick release deck to
make it easier to get to the batteries and the pc board.
To release the deck locate the two levers towards the
front of the deck. (FIG. 3). Pull up on the levers to
release the deck then slide it forward as you pull up
on it to remove it. To replace the deck simply slide the
deck back into place and push down until you feel the
levers snap into place.
The E-lite comes with 2 12V-8AMP batteries. The
batteries come in a pack that is located under the
deck. The battery pack has one set of wires coming
out of the bag.(Fig. 4) This wire is connected to the pc
board. The battery pack can also be removed from
the scooter and charged separately when you
purchase the hot swappable battery pack which
includes the charging adapter.
1. The scooter comes with a 1.1AH charger. (Fig. 5) To
charge your scooter you must plug the adapter in to
the control panel on the scooter (Fig. 5A) and plug the
charger into the wall. The LED light on the control
panel will let you know that status of batteries while
they are charging. For hot swap battery charging see
the instruction sheet that comes with the hot swap
battery pack.
*Note: full charging takes approx. 6-8 hours from full discharge. It
is recommended that you charge your Power Board after each
use.
2. To charge batteries externally. Purchase the hot swap
battery pack from your local dealer or from us here at
Bladez. www.ebladez.com
Page 8
or call us at 866-EBLADEZ