Lorex LH160 ECO6 SERIES Instruction Manual page 69

15 Using the Main Menu
To configure the Alarm tab:
1. From the Alarm menu, click the Alarm tab.
2. Configure the following:
• Alarm In: Select the channel you wish to configure.
• Alarm Type: Select the alarm type of the device. Choose from N/O (normally open),
N/C (normally closed).
• Alarm Out: Select the checkbox to enable the system's alarm block to trigger a con-
nected external alarm.
• Latch Time: Enter the duration the alarm continues to trigger after the event ends.
• Show Message: Select the checkbox if you want the system to display a system
message when an alarm triggers.
• Buzzer: Select the checkbox to enable the system to "beep" if an alarm triggers.
• Send Email: Select the checkbox if you want the system to send email notifications
if an alarm triggers.
• Post Recording: Select the duration the system continues to record as an event
after the alarm trigger ends. For example, if you select 30s (30 seconds), the system
continues to record for 30 seconds after the alarm trigger ends.
• Full Screen: Select the check box so that the system goes into full screen mode
when motion or an alarm trigger is detected.
3. Click Apply to save your settings.
#LX400007; r. 1.0/12121/12123; en-US
59