Lorex LH160 ECO6 SERIES Instruction Manual page 18

5 Rear Panel (LH160 Series)
7. On / Off Switch: Turns the DVR on or off.
8. DC12V: Connect the included AC power adapter.
9. USB Port(s): Connect a USB mouse (included) or USB flash drive (not included) for
data backup or firmware updates.
10. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
11. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
12. Audio Output: Output for 1 RCA audio channel (e.g. speakers).
24–Channel
1 2
12
1. Audio Input: Input for RCA audio-enabled cameras (not included).
2. Video Output: Outputs the DVR interface to a BNC connection. This allows you to see
your mouse cursor and have full control of the system on a secondary monitor. To
switch the mouse and system interface between BNC and VGA/HDMI monitors, press
0 three times on the remote control.
Note
Use a BNC to RCA adapter (not included) to connect the DVR to RCA inputs (i.e. for a TV
connection).
3. Video Input: Connect BNC cameras.
4. VGA: Connect a VGA monitor (not included) to view the system interface.
5. RS485/Alarm Block: Connect compatible PTZ cameras (not included) or alarm sen-
sor devices (not included).
6. IR EXT: Service only; not supported.
7. On / Off Switch: Turns the DVR on or off.
8. DC12V: Connect the included AC power adapter.
9. USB Port(s): Connect a USB mouse (included) or USB flash drive (not included) for
data backup or firmware updates.
10. LAN: Connect a CAT 5 RJ45 Ethernet cable for local and remote connectivity.
11. HDMI: Connect to an HDMI monitor or TV (not included) to view the system interface.
12. Audio Output: Output for 1 RCA audio channel (e.g. speakers).
#LX400007; r. 1.0/12121/12123; en-US
3 4 5 6
9 8 7
11 10
8