What To Do If - Electrolux EX601SC User Manual

Hide thumbs Also See for EX601SC:
Table of Contents

Advertisement

1. Unplug the appliance and then turn off
the water.
2. Leave the door ajar to prevent the forma-
tion of any unpleasant smells.
3. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location
where the temperature is below 0°C. If this is
unavoidable, empty the machine, close the
appliance door, disconnect the water inlet
pipe and empty it.

What to do if...

The appliance will not start or stops during
operation.
Certain problems can be due to the lack of
simple maintenance or oversights, which can
be solved with the help of the indications de-
scribed in the chart, without calling out a
service technician.
With the appliance door closed an inter-
mittent audible signal informs you that a
malfunction has occurred.
Fault codes and malfunction
• continuous flashing of the running programme
light
• The digital display shows
The dishwasher does not fill with water
• continuous flashing of the running programme
light
• The digital display shows
The dishwasher will not drain
• continuous flashing of the running programme
light
• The digital display shows
digital display
Anti-flood device is activated
Moving the machine
If you have to move the machine (moving
house etc...):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge
4. Pull the machine out together with the
Avoid over tilting the machine during trans-
portation.
Open the door and check which fault code
the digital display shows. Switch off the ap-
pliance and carry out the suggested correc-
tive actions given in the following chart.
For fault codes not described in the chart,
please contact your Customer Care Centre.
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the water inlet hose
is blocked.
Clean the filter.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• Close the water tap and contact your Customer
Care Centre.
appears in the
hoses.
hoses.
Possible cause and solution
electrolux 17

Advertisement

Table of Contents
loading

Table of Contents