Select And Start A Washing Programme - Electrolux EX601SC User Manual

Activate/deactivate the 'Tablet function'
before the start of a washing pro-
gramme.
Once the programme is running, the set
of the 'Tablet function' can NO longer be
changed. You must cancel the set pro-
gramme and then change the set of the
'Tablet function'.
Remember to set the washing pro-
gramme again.
Activation/deactivation of the Tablet
function
Simultaneously press and hold the two Tab-
let buttons (function buttons D and E ) until
the Tablet indicator light comes on. This
means that the function is active.
To deactivate the function press the same
buttons again until the Tablet indicator light
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the 'Tab-
let function' active.

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (refer to 'Washing
programmes' chart).
Close the dishwasher door, the pro-
gramme starts automatically.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C , until the lights of func-
tion buttons A , B , and C start flashing.
3. Press function button B , the lights of
function buttons A and C go off while the
light of function button B continues to
flash. The digital display shows the cur-
rent setting.
Rinse aid dispenser deactivated
Rinse aid dispenser activated
4. To change the setting, press button B
again, the digital display shows the new
setting.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the 'Tablet function'.
2. Fill up the rinse aid dispenser again.
3. Adjust the rinse aid dosage.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the flashing number of hours for the delay
start shows in the digital display.
The start of the selected washing pro-
gramme can be delayed for between 1
and 19 hours.
2. Close the dishwasher door, the count-
down starts automatically.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
electrolux 13