What To Do If - Electrolux GA60SLV220 User Manual

70 electrolux
1. Turn the filter (A) counterclockwise and
remove it out from filter (B).
B
A
2. Filter (A) has two parts. To disassemble
the filter, pull them apart.
3. Fully clean the parts with water.
4. Put the two parts of the filter (A) togeth-
er and push. Make sure that they as-
semble correctly in each other.

WHAT TO DO IF...

The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some malfunctions, the display
shows a message:
• OPEN THE TAP - The appliance does
not fill with water
Malfunction
The appliance does not fill with
water.
5. Remove the filter (B).
6. Fully clean the filter (B) with water.
7. Put the filter (B) to its initial position.
8. Put the filter (A) into position in filter (B).
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
• DRAIN BLOCKED - The appliance does
not drain the water
• SERVICE CODE
vice is on.
Possible cause
The water tap is blocked or
there is limescale on it.
Make sure that it assembles correctly in
the two guides (C).
Turn the filter (A) clockwise until it locks.
Warning! Deactivate the appliance
before you do the checks.
Possible solution
Clean the water tap.
C
- The anti-flood de-