Electrolux EX601SC User Manual page 21

Building-in
This appliance must be fitted under a kitchen
counter or work surface.
The dimensions of the recess must be the
same as shown in the figure.
No further openings for the venting of the ap-
pliance are required, but only to let the water
inlet hose, the drain hose and the mains ca-
ble pass through.
The appliance is fitted with adjustable feet
(max. 60 mm) so the height of the recess can
vary between 820 mm and 880 mm from the
floor.
Leave a space of 2 mm between the top of
the appliance and the underside of the kitch-
en counter.
Steam protection
Fit the steam protection onto the front part of
the work top using the screws provided.
Adjusting the height of the appliance
It is important that the appliance absolutely
stands level so that the door closes and seals
properly.
If the appliance is not perfectly level the door
will catch on the levelling spacers on the right
and left side of the cabinet.
Turn the adjustable feet to the left or the right
until the appliance stands level.
To adjust the height proceed as follows:
1. Remove the adjustable plinth.
2. Adjust the height of the 2 front feet.
3. Adjust the rear foot by turning the screw
in the middle of the front kick plate to the
left or to the right.
4. Replace the adjustable plinth.
Fix to the adjacent units
Warning! THE APPLIANCE MUST BE
SECURED UNDER THE WORK TOP OR
TO THE ADJACENT UNITS USING THE
SUPPLIED BRACKETS.
FAILURE TO DO THIS WILL CAUSE IN-
JURY OR DAMAGE.
1. Locate the supplied angular brackets in
the slots on the top of the appliance.
2. Adjust the height of the appliance.
3. Secure the appliance in position (up-
wards or sideways) by using the supplied
screws. Make sure the screws are tight-
ened.
Caution! Do not secure the brackets
upwards if the top of the appliance is not
within 2 mm of the underside of the work
top.
Caution! Never drill holes through the
sides of the appliance. This will cause
damage to the hydraulic components.
electrolux 21