Chicago Electric 95189 Operating Instructions Manual page 13

NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 21 and 24.
Pre-Start Checks:
1. Check to make sure the Engine's Power Switch (2) is in its
(See Figure B, next page.)
2. IMPORTANT! Prior to first using the Generator, the Engine MUST be filled
with approximately 3/4 (0.63) quart of a high quality SAE 10W-30 grade
engine oil. To do so, unscrew and remove the Oil Dipstick (54C) located at the
bottom of the Engine Crankcase. Pour engine oil into the oil Fill hole until the
level of oil is even with the bottom edge of the oil fill hole (if you cannot see the oil
through the oil fill hole, then the oil is too low and more oil must be added). Then,
screw the Dipstick back into the Oil Fill Hole. (See Figure c, next page.)
SKU 95189 For technical questions, please call 1-800-444-3353.
OPERATiNG iNSTRucTiONS
"OFF" position.
REV 10c
Page 13