Download  Print this page

What To Do If; Troubleshooting By Yourself - Electrolux EDC78550W User Manual

Hide thumbs

Advertisement

12 electrolux

WHAT TO DO IF ...

TROUBLESHOOTING BY YOURSELF

1)
Problem
Dryer not connected to mains supply.
Dryer does
not work.
Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
does not
Filters not locked in place.
close
Err (Error) on
Attempt to change parameters after
5)
start of the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis
elapsing time
of: type, volume and dampness of laun-
5)
dry.
on the LCD
Programme
Full water reservoir.
inactive
Drying cycle
Small laundry volume./Too dry laundry
to short
for selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle
Laundry insufficiently spun.
6)
to long
Particularly high room temperature - no
machine fault.
1) In case of error message on the LCD (e.g. E51- only dryers with the LCD): Switch the dryer off and on. Set
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaning chapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
CHANGING THE BULB FOR INTERIOR
LIGHTING
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local service centre.
Possible cause
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying
level (e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
Important! When the appliance is switched
on, the interior lighting switches itself off
after 4 minutes when the door is open.
Remedy
2)
3)
3)
4)
.
3)
, press START

Hide quick links:

Advertisement

loading

  Also See for Electrolux EDC78550W