Any changes of drying parameters re-
quire child lock deactivation.
The child lock cannot be deactivated in
the last phase of the drying cycle.
STARTING THE PROGRAMME
Press the Start/Pause button. The pro-
The programme progress is shown by
elapsing dry timeon the LCD.
To change a programme which has been
selected by mistake once the programme
has started, first turn the programme selec-
off and then set the programme
DRYING CYCLE COMPLETE /
Once the drying cycle is complete, the dis-
play shows the anti-crease icon
zer button has been pressed, an acoustic
signal sounds intermittently for about one
CLEANING AND MAINTENANCE
CLEANING FLUFF FILTERS
The filters collect all the fluff which accumu-
lates during drying. To ensure that the dryer
works perfectly, the fluff filters (fine filters
and fluff filters) must be cleaned after each
Caution! Never operate the dryer
without fluff filters or with damaged or
blocked fluff filters.
as well as warning
full tank. If the Buz-
The drying cycles are automatically fol-
lowed by an anti-crease phase which
lasts around 30 minutes. The drum ro-
tates at intervals during this phase. This
keeps the laundry loose and free of
creases. The laundry can be removed
at any time during the anti-crease
phase. (The laundry should be taken
out towards the end of the anti-crease
phase at the latest to prevent creases
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best
to use a damp hand for this purpose.
(See "Maintenance and cleaning" chap-
3. Remove laundry.
4. Turn the programme selector to
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Maintenance and clean-
5. Close the door.
CLEAN THE DOOR SEAL
Wipe the door seal with a damp cloth im-
mediately after the drying cycle has finish-