Cleaning The Drum; What To Do If; Troubleshooting By Yourself - Electrolux Iron Aid EDI97170W User Manual

It is best to use a brush or to rinse thor-
oughly with a hand-held shower.
8. Replace heat exchanger and lock into
place (turn both lock washers outwards
until they snap into place).
9. Close door in plinth.
The appliance will not operate if the
HEAT EXCHANGER indicator is still lit.
Caution! Never operate the dryer
without the heat exchanger.

Cleaning the drum

Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents
may form a barely visible lining on the in-

WHAT TO DO IF ...

Troubleshooting by yourself

If during operation, the error code E plus
number or letter) appears on the multi-dis-
play: Switch the appliance off and on again.
Problem
Dryer does not work.
IronAid programme does
not start. the water
tank indicator lights up.
After a IronAid pro-
gramme, garments are
not sufficiently smooth.
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the START/
PAUSE button?
Water tank is empty.
Recirculation valve is closed (OFF
position)
Wrong programme selected
(e.g. SYNTHETICS instead
of COTTON ).
Too low a LOAD level set.
Too many garments in machine,
or garments that are too different.
Clothes are not removed until the
anti-crease phase is finished.
Garments not hung on clothes
hangers and/or not tugged into
shape.
side of the drum. The degree to which
the laundry has been dried is then no
longer detected reliably. The laundry is
damper than expected when removed
from the appliance.
Use a standard domestic cleaner (e.g. vine-
gar-based cleaner) to wipe down the inside
of the drum and drum ribs.
Clean control panel and housing
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the control
panel and housing.
Reset programme. Press the START/
PAUSE button. If the error appears again,
please contact the Customer Care Depart-
ment, stating the error code
Plug in at mains socket. Check
fuse in fuse box (domestic installa-
tion).
Close loading door.
Press the START/PAUSE button
again.
Fill water tank.
Turn the recirculation valve to ON
position.
Note the composition of the fabric.
Set a higher LOAD level.
Load the machine with fewer gar-
ments, or only similar ones.
Remove clothes quickly one at a
time from the machine as soon as
possible after the start of the anti-
crease phase.
Hang garments on clothes hang-
ers, do up buttons and tug gar-
ments into shape.
electrolux 21
Remedy