Set Clock - NCI 125X User Manual

Online/Offl ine
Ext Ch Set
The choice to use the
extended character
set is available only
when 8 data bits are
chosen.
Print Ready

SET CLOCK

20
Choices:
YES - voltage will be in a low state until the unit is
busy then voltage level goes high.
NO - voltage will be in a high state until the unit is
busy then voltage level goes low.
ONLINE/OFFLINE is next.
Choices:
YES - enables the rocker switch to turn the printer
offl ine.
NO - disables the ONLINE/OFFLINE ability.
EXT CH SET is next. This stands for Extended Char-
acter Set.
Choices:
YES - Allows you to use hexidecimal numbers
above 80 (true only for 8 data bits.)
NO - Disables the Extended Character Set ability.
PRINT READY is next.
Choices:
YES - Prints Ready upon power up.
NO - Disables printing Ready
WARNING - If you choose NO, then you will
need to hold the left side of the rocker switch
down for 4 to 6 seconds to access the setup
menu. Begin timing when you connect power to
the unit and the red light comes on. The paper
feed motor does not run upon power up when
Ready is disabled.
The next item in the Setup Menu is SET CLOCK.
With the printer in the setup menu and with SET
CLOCK as the last item printed, if you press OK
(right side) the printer will print the following:
The printout shows the year currently in memory.
The 0 is reversed (white on black) to show the posi-
tion of the cursor. This is the number which will be
incremented if NEXT (left side) is pressed. If the
number is correct press OK (right side) and the fol-
lowing is printed:
Model 125X MiniPrinter Series User's Manual