NCI 125X User Manual page 17

Data Bits
Stop Bits
Handshake
Handshake is used for
serial interface only
Columns
Invert
Font
Magnifi cation
DATA BITS is the next parameter. Choose the data
bit value the same way baud rate was chosen.
Choices are 7 or 8 data bits. If you choose 7 data
bits you can select EVEN or ODD parity. If you
choose 8 data bits parity defaults to NONE.
STOP BITS is the next parameter. Choose 1 or 2
stop bits. 1 stop bit is used for 10 bit words, 2 stop
bits are used for 11 bit words.
HANDSHAKE is the next parameter. Choose from
the following settings:
BUSY-LINE
BUSY-BUFFER
XON/XOFF-LINE
XON/XOFF-BUFFER
NONE
COLUMNS is the next parameter. Select the number
of characters per line (columns) for this parameter.
The choices you have are 24, 32, or 40. Below are
samples of each:
INVERT is the next parameter. Choose YES if you
want inverted text (upside down) or NO if you want
non-inverted text (right side up) in your printouts.
Below is an example of inverted text.
FONT is the next parameter. Choose from a 5 x 5,
5 x 7, or 5 x 8 dot matrix print pattern. The 5 x 5 dot
pattern produces only upper case (capital) letters.
The other two fonts can output upper and lower case
letters.
The last parameter is MAGNIFICATION. This refers
to the size of printed type from your printer. Your
choices (with examples) are
NONE
Model 125X MiniPrinter Series User's Manual
17