Additional Harnesses And Connectors For The System - Audiovox AS-9234 Installation Manual

1 Black: 250mA Output (-)
The black wire switches on when the remote start is activated and will stay on as programmed in the
remote start feature Bank 3 Feature 12.
2 Red: 250mA Output (+) 12 Volts Constant
This output is intended to allow the control of a transponder bypass interface module or transponder
bypass relay.

Additional Harnesses And Connectors For The System

4 Pin Upgrade Telematic Module:
Red = + 5 Volts / Black = Ground / White = Data TX / Yellow = Data RX
Connect the 4 pin harness found in the Telematic one way or CArlink II kits to the mating port on the
controlling circuit.
NOTE: If using the TWO WAY Telematic module, only Ground, TX, and RX are used on this port, the
+ 12 Volt supply for the two way module must be sourced separately or the unit will not operate.
Optional Receiver Program Push-Button Switch/LED Connector:
The Gray and the Blue wires loaded into individual 2 pin connectors,and the Black, Green & Red wires
loaded into the 3 pin black connector are the Valet enable, LED cathode, & the RF power, ground,and RX.
When the Gray wire is grounded under certain conditions, the unit will enter the valet mode. When the Gray
is sequentially grounded under other conditions, the unit will enter various program modes indicated on the
LED built into the receiver. Route the Blue, White, and Black connectors from the receiver assembly to the
remote start unit and plug these connectors into the mating connectors of the control module.
4 Pin Shock Sensor: (White Connector)
The Red (+12 Volt), Black (ground), Blue (pre-detect) and Green (full trigger when armed) wires loaded into
the white connector shell are the inputs/outputs of the shock sensor. Route the 4 wire harness from the
shock sensor to the remote start control unit and plug the 4 pin white connector into the mating 4 pin
connector shell of the control module.
NOTE: While operating under the control of the remote start unit the shock sensor will be shunted (by
passed). Once the remote start shuts down, the shock sensor will be re-enabled.
4 PIN IN VEHICLE DATA BUS PORT (DBI Port)
The 4 pin port located on the side of this module is for proprietary Audiovox data bus interface modules.
These modules are used to access a variety of features in the vehicle which can be as simple as door trigger
inputs, to more complex door locks outputs, or transponder interfaces for remote starting. DO NOT connect
anything to this port other than the Audiovox IDB modules or damage to the Remote Start module will occur.
All installation instructions for the IDB modules will be packaged with the individual component along with
the proper 4 pin wiring harness requires to access the data transmit & receive as well as the proper voltage
levels for the interface.
Connector Port)
Part #'s AddPr or AddSS
(Connector Port)
17
Part # 1122591
128-8971a
17 of 32