Zigzag Stitching; Placement Of Patterns - Singer 7468 Instruction Manual

ZIGZAG STITCHING

SETTINGS :Presser foot - General Purpose Foot
:Thread tension control - AUTO
The top thread may appear on the bottom depending on the
thread, fabric, type of stitch and sewing speed, but the bobbin
thread must never appear on the top of the fabric.
If bobbin thread is pulling to the top or you are experiencing
Puckering, slightly reduce the tension with the Thread Tension
Control.
ADJUSTING STITCH WIDTH AND LENGTH
Dark grey box indicates the Auto/default value set
automatically when the pattern is selected.
For the Zigzag Pattern the stitch length is 2 mm and the
stitch width is 5 mm.
The light grey boxes indicate all the possible personal
preference options available to set manualy.
NOTE: The values shown in the chart are actual sewing
lengths and widths and do not correspond to the scale
and number markings on the sewing machine.
SATIN STITCH
This is a closely spaced attractive stitch for appliqué, bar-
tacking, etc. Slightly loosen the top thread tension and manually
adjust the stitch length between 0.5 and 2.0 for satin stitching.
Use a backing of stabilizer or interfacing for sheer materials to
avoid puckering.
NOTE: When sewing a dense (closely spaced) Satin
Stitch, the Satin Stitch Foot MUST be used.

PLACEMENT OF PATTERNS

Stitch width of pattern increases from center needle position as
illustrated.
46
Under side
Côté de dessous
Reverso
Top side
Côté de dessus
Cara
STITCH WIDTH
LARGEUR DU POINT
ANCHO PUNTADA
0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0
mm
0
0.25
0.5
0.75
1.0
1.25
1.5
1.75
2.0
2.5
3.0
Center position
Position centrale
Aguja posicionada en el centro