When Your Security System Is Triggered; Basic Troubleshootingemergency Disarm Procedure - Code Alarm CA-640 Owner's Manual

When Your Security System is Triggered

The Code Alarm CA-640
occurs while the system is armed:
• Any protected entrance is opened
• The vehicle ignition is turned ON
• The vehicle is jolted hard enough to signal the impact sensor
Once the alarm is triggered, the siren (or horn) sounds and the
vehicle parking lights flash for 30 seconds. The system will then re-
arm, awaiting the next intrusion attempt. To stop the siren while
keeping the alarm armed and doors locked, press the LOCK button
while the system is triggering.
The Status Indicator is a high-intensity blue light mounted in a visible
location on the vehicle dashboard. This blue light gives a visual
indication of the alarm system's state of operation. Note the chart
below:
If the Status Indicator is...
Off
Flashing Slowly
Flashing Very Quickly
Flashing Intermittently
(2 flashes, off, 2 flashes)
On (not flashing)
ca-640 owners.pmd
TM
will trigger if one of the following events
....then the Security System
is disarmed
is armed
was triggered in your absence
(see Attempted Intrusion ID - page 5)
is in Valet mode
is in Pre-arm mode
11
11
9/9/2004, 4:19 PM