When Your Security System Is Triggered; Override Button - Code Alarm Vehicle Security System Owner's Manual

When Your Security System is Triggered

The security system will trigger if one of the following events occurs while it is
armed:
Once the alarm is triggered, the alarm sounds its 125db siren and flashes the
vehicle parking lights for 30 seconds. The system will then re-arm, awaiting the next
intrusion attempt.
OVERRIDE/PROGRAMMING BUTTON
The Override/programing button is a hidden push button switch that can be used to
disarm the security system if your remote control transmitter is lost or stolen. The
override/ programming button is also used to for programming new transmitters to
the system. To prevent unauthorized use of the override/programming button, the
ignition key is also needed to disarm the system or program transmitters.
Disarming system without the remote control transmitter
1. Enter vehicle (the alarm will begin sounding as soon as the door is opened).
2. Turn the ignition key to the on position.
3. Press the override button.
4. The security system is now disarmed.
Note: System will rearm 60 seconds after key is turned off. (If automatic arming is
enabled)
6
• Any protected entrance is opened
• The vehicle ignition is turned on
• The vehicle is jolted hard enough to signal the impact detector