Code Alarm CA-640 Owner's Manual page 13

Transceiver Remote Control Programming,
Clock Programming:
1. Press and hold SET until you hear 2 Beep Tones. The clock
hour will start flashing.
2. Press FIND/PANIC to advance hour, press START to reduce
hour.
3. Press SET, minutes will begin flashing.
4. Press FIND/PANIC to advance minutes, press START to reduce
minutes. The remote control will automatically exit programming.
Alarm Programming:
1. Follow steps 1-3 of "Clock Programming" above.
2. Press SET, hour will begin flashing.
3. Press FIND/PANIC to advance hour, press START to reduce
hour.
4. Press SET, minutes will begin flashing.
5. Press FIND/PANIC to advance minutes, press START to reduce
minutes.
6. Press SET, press FIND/PANIC to select alarm on, press START
to select alarm off.
Countdown Timer Programming:
1. Follow steps 1-3 of "Clock Programming" and1-6 of "Alarm
Programming" on previous page.
2. Press SET, hour will begin flashing.
3. Press FIND/PANIC to advance hour, press START to reduce
hour.
4. Press SET, minutes will begin flashing.
5. Press FIND/PANIC to advance minutes, press START to reduce
minutes.
6. Press SET, press FIND/PANIC to select countdown timer on,
press START to select countdown timer off.
Turning Vibrate (Silent) Mode On:
1. Press SET, within 3 seconds push and hold UNLOCK. Follow
the same procedure to turn vibrate mode off.
Turning On Battery Saver Mode:
1. Press and hold SET for 5 seconds or until SAVE apears on the
display. Press any remote control button to exit battery saver mode.
Turning On Button Lock:
1. Press SET, within 3 seconds push and hold LOCK. Follow
the same procedure to turn vibrate mode off.
ca-640 owners.pmd 13
13
9/9/2004, 4:28 PM