Using Your Remote Transmitter; Arming The Security System; Pre-Arm Mode; Disarming The Security System - Code Alarm CA-640 Owner's Manual

Remote start, security and convenience system
Table of Contents

Advertisement

Using Your Remote Transmitter

The functions in this section can operated using either the two-
s
way confirming transceiver or the one-way transmitter. Button
configurations are shown in the graphic below.
"LOCK/ARM"
"FIND/PANIC"

Arming the Security System

To arm the system, exit the vehicle, close all doors, then press the
LOCK/ARM button. The siren will "chirp" twice and the parking lights
will flash twice, indicating the system is armed. The doors will also
lock at this time (if equipped and connected). The status indicator
(blue warning light on the dash) will blink steadily, once per second.

Pre-arm Mode

If the siren chirps and the parking lights flash only once, this indicates
that the vehicle courtesy light is on, or that an entrance is not closed
securely. Check to see that doors, hood, and trunk are properly
closed. Once all entrances are secured (and the courtesy light is off),
the system will chirp / flash again. The system is now fully armed.
(If the entrance is not secured within 4 minutes, the system will arm
and ignore the unsecured entrance until it is closed.)

Disarming the Security System

To disarm the system, press the UNLOCK/DISARM button. The siren
will chirp and the parking lights will flash once, and the doors will
unlock. The courtesy light will turn on for 1 minute, or until the vehicle
is started.

Attempted Intrusion Identification

If the siren chirps four times when
disarming, this indicates that the
system was triggered in your
absence. The status indicator will
also flash rapidly. Perform the
following operation to determine the
protected zone that triggered the
system: After disarming, press the
emergency override button. The siren will chirp to indicate the cause
of the alarm trigger:
* Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to
pressing for more than 1 second. **'Siren' also refers to the vehicle horn if it is used as the alarm sounding
device.*
ca-640 owners.pmd
"UNLOCK/DISARM"
1 chirp IT-s Interior Theft Sensor
2 chirps Door
3 chirps Hood
4 chirps Trunk/Optional Sensors
5 chirps Ignition was turned ON
5
5
"START"
"SET"
9/9/2004, 4:19 PM

Advertisement

Table of Contents
loading

Table of Contents