Suzuki LT-F400 Owner's Manual page 83

Mark top dead center
Oil filter wrench
In the position at
which the filter
gasket first contacts
the mounting
surface.
9. Mark the top dead center posi-
tion on the "cap type" filter
wrench or on the oil filter. Use
an oil filter wrench to tighten
the filter 2 turns or to specified
torque.
Oil filter tightening torque:
20 N·m (2.0 kgf-m, 14.5 lb-ft)
Tighten the filter
2 turns or
to specified torque.
10.Reinstall the drain plug and
tighten it securely. Pour about
3.2 L (3.4 US qt) of the speci-
fied oil in the filler hole. (See
FUEL AND OIL RECOMMEN-
DATIONS section).
CAUTION
Failure to use the correct oil
can damage your ATV.
Engine damage may occur if
you use oil that does not meet
Suzuki's specifications.
Be sure to use the oil specified
in the FUEL AND OIL RECOM-
MENDATIONS section.
11.Start the engine (while the
vehicle is outside on level
ground) and allow it to idle for
three minutes.
12.Turn the engine off and wait for
three minutes. Recheck the oil
level with the engine oil dip-
stick. The oil level should be at
the "F" (full) mark. If it is lower
than the "F" mark, add oil until
it reaches
Inspect the area around the
drain plug and oil filter for
leaks.
www.quad-forum.sk
5-15
the "F" mark.