Reconstructing the blade
WARNING! Ring cutter blades must not be
reconstructed. Due to its design, a ring
cutter blade is exposed to other strains than
a centre driven 14 inch diamond blade.
Firstly, the drive wheel is driven on the inner
diameter of the blade so that both the
surfaces of the drive wheel and the blade are
exposed to wear. The core of the blade
becomes thinner and the guide wider, which
prevents the blade being driven by the
wheel. Secondly, the blade is exposed to
loads from the rollers and from the actual
cutting process when the blade is not held
completely straight. Strain builds up in the
blade until it cracks or breaks if it has been
reconstructed. A shattered blade can cause
serious personal injuries to the user or other
persons. For this reason Husqvarna does
not approve ring cutting blades that have
been reconstructed. Contact your
Husqvarna dealer for instructions.
2 Water ﬁlter
IMPORTANT! If the coupling is dirty, the dirt can enter the oil
and cause increased wear on the hydraulic motor, hydraulic
pump, valves, etc. It can also prevent the coupling from
Always clean the couplings before connecting to the hydraulic
system and the machine. Make sure the lock moves easily.
Clean the water ﬁlter if necessary.
Check the hydraulic hoses everyday before the machine is
used. Cracked, creased or weakened hoses must be