Husqvarna K 3600 MKII Operator's Manual: Drive Wheel; Replacing The Support Rollers/guide Rollers

Husqvarna concrete ring saw operator's manual.
Hide thumbs

Advertisement

Drive wheel

1 Lock the axle using the locking button. See the
instructions under the heading What is what?.
2 Loosen the centre screw and remove the washer.
3
You can now lift off the drive wheel.
CAUTION! Replace the drive wheel when fitting a new blade.
A worn drive wheel can result in the blade slipping and
becoming damaged.
Inadequate water flow drastically shortens the life of the drive
wheel.
Replacing the support rollers/guide
rollers
Remove the support roller cover.
Check the rollers for wear.
Use a 19 mm spanner and 5 mm hex key to replace the
rollers.
Lubricate using bearing grease inside the rollers before the
new rollers are fitted.
Replace the guide rollers when half of the flange on the
rollers is worn.
A) New
16 –
English
MAINTENANCE
B) Worn
Replace the support rollers when the roller surface is flat,
(or) when the groove on the roller surface has worn away.
A) New
B) Worn
When worn rollers are replaced with new ones, you must
adjust the rollers against the blade. See the instructions under
the heading Settings and adjustments.

Advertisement

   Related Manuals for Husqvarna K 3600 MKII

Comments to this Manuals

Symbols: 0
Latest comments: