Tools Included; Pre-Assembly; Assembly Step - Tempo Fitness 612T Owner's Manual

pRE ASSEMBLY

TOOlS INClUdEd:

F 4 mm Allen Wrench
F 5 mm L-Wrench/Screwdriver
UNpACkING
F 6 mm T-Wrench
Place the treadmill carton on a level flat surface. It is recommended that you place a
All
pARTS INClUdEd:
protective covering on your floor. Take CAUTION when handling and transporting this
mOdElS
unit. Never open box when it is on its side. Once the banding straps have been removed,
F 1 Safety Key
do not lift or transport this unit unless it is fully assembled and in the upright folded
F 1 Console Assembly
position, with the lock latch secure. Unpack the unit where it will be used. Never grab
F 2 Console Masts
hold of any portion of the incline frame and attempt to lift or move the treadmill.
F 2 End Caps
F 612T: 2 Handlebars
F 612T: 4 Hardware Bags
F 622T: 5 Hardware Bags
F 622T: 2 Frame Extension Tubes
F 1 Bottle of Silicone Lubricant
(for 2 applications)
F French Overlays
NEEd HElp?
If you have questions or if
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
there are any missing parts,
partially threaded in before completely tightening any ONE bolt.
contact Customer Tech
Support. Contact information
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
is located on the back panel
such as lithium bike grease is recommended.
of this manual.
10
TEM_12_612T_622T_OM_rev1_1.indd 10-11
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

ASSEMBLY STEp 1

HARdWARE bAG 1 CONTENTS :
BOLT (A) SPRING WASHER (B)
20 mm 8 mm
Qty: 4 Qty: 4
622T PLUS
612T
LEFT CONSOLE MAST
LEFT CONSOLE MAST
ARC WASHERS (D)
BOLTS (A)
SPRING WASHERS (B)
FLAT WASHERS (C)
BASE FRAME
FLAT WASHER (C) ARC WASHER (D)
mOdElS
8 mm 8 mm
Qty: 2 Qty: 2
A Cut the yellow banding straps and lift the
running deck upward and remove all
contents from underneath the running deck.
Open hardware bag 1.
B
With the running deck lowered, attach
C
the left console mast to the base
frame using 2 bolts (a), 2 spring
washers (b) and 2 flat washers (c)
from the side and 2 bolts (a), 2 spring
washers (b) and 2 arc washers (d)
from the rear.
2/28/12 8:32 AM
All
11