For U.k Users - Panasonic DP-2310 Operating Instructions Manual

<For U.K Users>
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A 13 amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amps and that it is
approved by ASTA or BSI to BS1362.
Check for the ASTA mark
If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR OFFICE THEN THE FUSE
SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE
ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
WARNING: THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are colored in accordance with the following code:
Green and Yellow : Earth
Blue : Neutral
Brown : Live
As the colors of the wires in the main lead of this appliance may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows:
The wire which is colored GREEN-AND YELLOW must be connected to the terminal in the plug which is marked by letter
E or by the safety Earth symbol "
The wire which is colored BLUE must be connected to the terminal in the plug which is marked with the letter N or colored
BLACK.
The wire which is colored BROWN must be connected to the terminal in the plug which is marked with the letter L or
colored RED.
How to replace the fuse.
Open the fuse compartment with a screwdriver and replace the fuse.
or the BSI mark on the body of the fuse.
" or colored GREEN or GREEN-AND-YELLOW.
163