Front-Wheel Stand - BMW S 1000 RR Rider's Manual

Threaded fasteners not
7
tightened to the specified
torque can work loose or their
90
threads can suffer damage.
Always have the security of the
fasteners checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
Seat the rear wheel on the
rear-wheel adapter.
z
Tighten screws 1 to specified
torque in diagonally opposite
sequence.
Rear wheel to drive shaft
Tightening sequence:
Tighten in a crosswise
sequence
60 Nm
without centre stand
Remove the auxiliary stand.

Front-wheel stand

Installing the front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support the motorcycle
without the assistance of an
auxiliary stand. A motorcycle
resting only on the front wheel
stand and the rear wheel can
topple.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad

front-wheel stand.

Place the motorcycle on an
auxiliary stand; BMW Motorrad
recommends the BMW Motor-
rad rear-wheel stand.
Installing the rear-wheel stand
( 92).
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Use basic stand with front-
wheel adapter . The basic
stand and its accessory com-
ponents are available from
your BMW Motorrad author-
ised dealer.
OE