Jump Start; Installing Centre Trim Panel - BMW S 1000 RR Rider's Manual

Installing centre trim
panel
Slip the centre trim panel un-
derneath the left and right side
panels at position 1 and then
seat it in guides 2 on left and
right.
Damage to the paintwork
as a result of screw con-
nections.
For painted components, plastic
discs should be inserted under
the screw heads.
Install four screws 1 on left and
right.
Trim panels
2 Nm
Installing the seat (

Jump start

The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
vehicle electronics.
Do not use the on-board socket
to jump-start the engine of the
motorcycle.
A short-circuit can res-
ult if the crocodile clips
of the jump leads are accident-
ally brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the vehicle
54).
electronics.
Make sure that the battery of the
7
99
z