BMW S 1000 RR Rider's Manual page 93

Slacken securing screw 1.
Push the two adapters 2 apart
until the telescopic forks fit
between them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
Align the two adapters 2 so
that the telescopic forks are
securely seated.
Tighten securing screw 1.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
OE
with centre stand
If the motorcycle is raised
too far the centre stand will
lift clear of the ground and the
motorcycle could topple to one
side.
When raising the motorcycle,
make sure that the centre stand
remains on the ground. If ne-
cessary, adjust the height of the
front-wheel stand.
7
91
z